NO.44 Referring to the exhibit, you have a data center with two PODs. Seamless EVPN-VXLAN stitching is used to facilitate communication between the PODs.

Which three statements are true in this scenario? (Choose three.)

NO.45 Referring to the exhibit, what would cause the problem on VCP 0/50?

NO.46 Exhibit.


Referring to the exhibit, you want to advertise the IRB routes between both routing instances.
Which two configuration parameters would be applied to accomplish this task? (Choose two.)

NO.47 You are asked to deploy an Ethernet bridging design in a data center with the following criteria:
– routing must occur on the leaf devices.
– VTEPs must terminate on the leaf devices.
– facilitate inter-VLAN communication.
– lower latency with East-West traffic.
Which architecture should you use in this scenario?

NO.48 You are creating a new EVPN and are asked to selectively accept certain MAC advertisement routers from your EVPN peers using VXLAN Encapsulation.
Which statements is correct in this scenario?

NO.49 An EVPN-signaled VXLAN overlay has been deployed in the network shown in the exhibit. Host1 is a bare metal server, and is dual-homed to the network. The IP addresses 10.1.1.1/24 and 10.1.1.2/24 are assigned to the same physical NIC, and no virtualization is configured on the server.

In this scenario, which two statements are true? (Choose two.)

NO.50 Exhibit.

Referring to the exhibit, which two statements are correct? (Choose two.)

NO.51 Referring to the exhibit,

what effect does EVPN core isolation have?

NO.52 You want to enable an EBGP-based IP fabric to allow ECMP routes to be populated into the RIB. In this scenario, which action will accomplish this task?

NO.53 A company wants to expect their hosting business and is seeking solutions to supported multiple tenants. Each tenant should be able to configure their own logical interfaces. Also, based on customer needs, all routing features must be supported.
What will satisfy the customer’s requirements?

NO.54 Which two statements describe a VXLAN network identifier (VNI)? (Choose Two)

NO.55 Which two statements describe MAC address learning for VPLS and EVPN? (Choose two.)

NO.56 Which statement is true about the route shown in the exhibit?

NO.57 You have configured MP-IBGP to support EVPN for your overlay network. However, you are not seeing the
expected routes on your edge devices.

Referring to the exhibit, how would you solve this problem?

NO.58 Exhibit.

An EVPN-signaled VXLAN overlay has been deployed in the network shown in the exhibit. An EVPN LAG has been configured to connect host1 to the network,
and device leaf1 has been elected as the designated forwarder.In this scenario, which statement is true?

NO.59 You have a two spine and four leaf CRB topology and you must ensure that the hosts connected to the leaf devices have reachability to all IRB interface addresses, including the local spine IRB addresses, and the virtual gateway address.
Which two configuration parameters must be used to accomplish this task? (Choose two.)

NO.60 Referring to the exhibit, DC1 and DC2 have a DCI across a service provider WAN connection. Host1 in DC1 must have Layer 2 connectivity to host2 in DC2. A VXLAN tunnel must be created between VTEP1 and VTEP2.

In this scenario, which statement is true?

NO.61 Exhibit.

Site 1 contains 20+ VMs. The link between Site 1 and Leaf1 goes down.
Referring to the exhibit, which statement is correct?

NO.62 What is an advantage that EVPN has over VPLS when used for DC I?

NO.63 Site 1 contains 20+ VMs. The link between Site 1 and Leaf1 goes down.
Referring to the exhibit, which statement is correct?

NO.64 You want to configure redundant Layer 3 gateways
In this scenario, which two juniper best practices would accomplish this task? (Choose two.)

NO.65 You have deployed a multitenant EVPN-VXLAN fabric. You must have the routes in the BLUE VRF show up in the RED VRF. In this scenario, how would you achieve this goal?

NO.66 You want to ensure high availability of the Junos devices in your data center. In this scenario, which three features would accomplish this task? (Choose three.)