Q98. After experiencing traffic disruptions from the failure of a single router, a customer asks an engineer to design a solution that will prevent this from occurring in the future. While examining the customer’s environment, the engineer discovers that the routers are manufactured by a variety of different vendors, and they have varying amounts of CPU and memory resources. Additionally, several of the customer’s applications require the ability to fine-tune the load-balancing parameters between multiple gateway routers.
Which solution should be used to meet these requirements?

Q99. A company must introduce a scalable network automation tool to deploy, configure, and manage thousands of network device and service. The company servers already have been security-hardened and must not have any additional software installed on team. The security policy mandates the use of a secure communication protocol that support authentication and encryption for managing the servers. Which two automation tools must be used to meet these requirements? (Choose two.)

Q100. Drag the appropriate from the left onto the current UDLD modes of operation on the right.

Q101. Refer to the exhibit.

A Cisco UCS chassis that has two IOMs is discovered. The chassis discovery policy creates a fabric port channel. What is the result of this policy?

Q102. An engineer configured the OSPF protocol in the vPC topology. During the catastrophic failure of one of the vPC the member switches, the traffic was routed to a black hole. This route was caused by the long convergence time caused by the delay of the of the vPC member switch reboot. After the failure, the engineer rebooted both switches, but the secondary switch powered on before the primary one. It caused all the vPCs to be shut down due to consistency-check violations. Which two features must be used to prevent these situations from happening in the future? (Choose two.)

Q103. Drag and drop the SAN components from the left onto the correct design considerations on the right.

Q104. What are two functions of a Network Services Orchestrator in an NFV environment? (Choose two.)

Q105. Drag and drop the configurations from the left onto the correct policies on the right.

Q106. An engineer is implementing a Cisco UCS environment. The system must aggregate all vNICs into a single policy and consistently enforce node disassociation across the cluster. Which two UCS policies meet these requirements? (Choose two.)

Q107. Drag and drop the data center technologies from the left onto the correct descriptions on the right. Not all technologies are used.

Q108. An engineer is expanding an existing ISCSI environment and must choose an addressing scheme. When checking one of the devices, the engineer discovers this target device naming used
{prefix}. 2019-01.com.acme.123:00. ftd0cb21.bcb389458389
Which addressing scheme was used in the environment?

Q109. Which two configurations are available by using a service profile template in Cisco UCS Manager? (Choose two.)

Q110. Refer to the exhibit.

What must be the default gateway of the servers in EPG Web?

Q111. Drag and drop the SAN components from the left onto the correct design considerations on the right.

Q112. Which mode must be enabled on a Cisco UCS Fabric Interconnect to connect directly to a storage array?

Q113. Refer to the exhibit.

Server 1 fails to connect to the storage array over the Storage Area Network (SAN) of the Cisco NDS 9000 Series Switch. The requirements are to redesign the storage network and keep these considerations in mind:
The traffic from each of the server must be redundant and isolated.
The design must tolerate hardware and software failures and upgrades of SAN fabric devices.
Which action must be taken to meet these requirements?

Q114. Refer to the exhibit.

What must be the default gateway of the servers in EPG Web?

Q115. An engineer enables the HSRP feature on a Cisco Nexus 7000 Series Switch. It must be ensured that the switch manages packets that are sent to the local vPC MAC address, remote vPC MAC address, and HSRP virtual MAC address.
Which command accomplishes this goal?