[Q36-Q54] The Best Valid NSE7_EFW-7.2 Dumps for Helping Passing NSE7_EFW-7.2 Exam!

4/5 - (2 votes)

The Best Valid NSE7_EFW-7.2 Dumps for Helping Passing NSE7_EFW-7.2 Exam!

UPDATED Fortinet NSE7_EFW-7.2 Exam Questions & Answer

NEW QUESTION 36
Refer to the exhibit, which contains a CLI script configuration on FortiManager. An administrator configured the CLI script on FortiManager, but the script failed to apply any changes to the managed device after being executed.

What are two reasons why the script did not make any changes to the managed device? (Choose two)

The commands that start with the # sign did not run.

Incomplete commands can cause CLI scripts to fail.

Static routes can be added using only TCI scripts.

CLI scripts must start with #!.

NEW QUESTION 37
After enabling IPS, you receive feedback about traffic being dropped.
What could be the reason?

IPS is configured to monitor.

np-accel-node is set to enable.

fail-open is set to disable.

traffic-submit is set to disable.

NEW QUESTION 38
Which two statements about the Security Fabric are true? (Choose two.)

FortiGate uses the FortiTelemetry protocol to communicate with FortiAnalyzer

Only the root FortiGate sends logs to FortiAnalyzer

Only FortiGate devices with configuration-sync set to default receive and synchronize global CMDB objects that the root FortiGate sends

Only the root FortiGate collects network topology information and forwards it to FortiAnalyzer

NEW QUESTION 39
Refer to the exhibit, which shows an error in system fortiguard configuration.

What is the reason you cannot set the protocol to udp in config system fortiguard?

udp is not a protocol option.

fortiguard-anycast is set to enable.

You do not have the corresponding write access.

FortiManager provides FortiGuard.

NEW QUESTION 40
Winch two statements about ADVPN are true? (Choose two)

auto-discovery-receiver must be set to enable on the spokes

Spoke to-spoke traffic never goes through the hub

lt supports NAI for on-demand tunnels

Routing is configured by enabling add-advpn-route

NEW QUESTION 41
Refer to the exhibits, which show the configurations of two address objects from the same FortiGate.

Why can you modify the Engineering address object, but not the Finance address object?

You have read-only access.

FortiGate joined the Security Fabric and the Finance address object was configured on the root FortiGate.

FortiGate is registered on FortiManager.

Another user is editing the Finance address object in workspace mode.

NEW QUESTION 42
An administrator is configuring two FortiGate devices in an HA cluster. While configuring the devices, the administrator issues the following commands on both HA cluster members:

In which two ways do these commands impact the HA cluster? (Choose two.)

They force the former primary to send gratuitous ARP packets when the failover happens to indicate that the virtual MAC address is now using a different device.

They force the former primary to shut down all ts interfaces for one second when failover happens, excluding the heartbeat and reserved management interfaces.

They force both HA devices for remote link monitoring to detect an issue in the forwarding path.

They force the switches to update their MAC forwarding tables, when failover happens.

NEW QUESTION 43
Refer to the exhibit, which contains a partial BGP combination.

You want to configure a loopback as the OGP source.
Which two parameters must you set in the BGP configuration? (Choose two)

ebgp-enforce-multihop

recursive-next-hop

ibgp-enfoce-multihop

update-source

NEW QUESTION 44
Which ADVPN configuration must be configured using a script on fortiManager, when using VPN Manager to manage fortiGate VPN tunnels?

Enable AD-VPN in IPsec phase 1

Disable add-route on hub

Configure IP addresses on IPsec virtual interlaces

Set protected network to all

NEW QUESTION 45
Exhibit.

Refer to the exhibit, which shows information about an OSPF interlace
What two conclusions can you draw from this command output? (Choose two.)

The port3 network has more man one OSPF router

The OSPF routers are in the area ID of 0.0.0.1.

The interfaces of the OSPF routers match the MTU value that is configured as 1500.

NGFW-1 is the designated router

NEW QUESTION 46
What is true about the Fitter override option in the application control profile?

Helps to configure actions for predefined categories

Helps to categorize applications based on behavior risk or on technology

Helps to view the application control signatures for a specific category

Helps to control specific signature and applications

NEW QUESTION 47
Refer to the exhibit, which contains the partial ADVPN configuration of a spoke.

Which two parameters must you configure on the corresponding single hub? (Choose two.)

Set auto-discovery-sender enable

Set ike-version 2

Set auto-discovery-forwarder enable

Set auto-discovery-receiver enable

NEW QUESTION 48
Examine the output of the ‘get router info ospf interface’ command shown in the exhibit; then answer the question below.

Which statements are true regarding the above output? (Choose two.)

The port4 interface is connected to the OSPF backbone area.

The local FortiGate has been elected as the OSPF backup designated router

There are at least 5 OSPF routers connected to the port4 network.

Two OSPF routers are down in the port4 network.

NEW QUESTION 49
Refer to the exhibit, which shows an SSL certification inspection configuration.

Which action does FortiGate take if the server name indication (SNI) does not match either the common name (CN) or any of the subject alternative names (SAN) in the server certificate?

FortiGate uses the first entry listed in the SAN field in the server certificate

FortiGate uses the CN information from the Subject field in the server certificate

FortiGate uses the SNI from the user’s web browser.

FortiGate closes the connection because this represents an invalid SSL/TLS configuration

NEW QUESTION 50
You want to configure faster failure detection for BGP.
Which parameter should you enable on both connected FortiGate devices?

Ebgp-enforce-multihop

bfd

Distribute-list-in

Graceful-restart

NEW QUESTION 51
Exhibit.

Refer to the exhibit, which contains a partial VPN configuration.
What can you conclude from this configuration1?

FortiGate creates separate virtual interfaces for each dial up client.

The VPN should use the dynamic routing protocol to exchange routing information Through the tunnels.

Dead peer detection s disabled.

The routing table shows a single IPSec virtual interface.

NEW QUESTION 52
Refer to the exhibit.

The partial interlace configurator! of two FortiGate devices is shown
Which two conclusions can you draw from this configuration? (Choose two.)

You can include 4.4.4.4 and 4.4.4.2 IP addresses using sat vrdst command

At the time of failover, FortiGate_A will change its priority to 30

By default, preemption mode is enabled

In VRRP, you are restricted to add a third FortiGate into VRRP group 1.

NEW QUESTION 53
Refer to the exhibit, which shows the output of a BGP summary.

What two conclusions can you draw from this BGP summary? (Choose two.)

External BGP (EBGP) exchanges routing information.

The BGP session with peer 10. 127. 0. 75 is established.

The router 100. 64. 3. 1 has the parameter bfd set to enable.

The neighbors displayed are linked to a local router with the neighbor-range set to a value of 4.

NEW QUESTION 54
You want to configure faster failure detection for BGP.
Which parameter should you enable on both connected FortiGate devices?

Ebgp-enforce-multihop

bfd

Distribute-list-in

Graceful-restart

Fortinet NSE7_EFW-7.2 Exam Syllabus Topics:

Topic	Details
Topic 1	Central management: The topic of Central management covers implementing central management.
Topic 2	System configuration: This topic discusses Fortinet Security Fabric and hardware acceleration. Furthermore, it delves into configuring various operation modes for an HA cluster.
Topic 3	Routing: It covers implementing OSPF to route enterprise traffic and Border Gateway Protocol (BGP) to route enterprise traffic.
Topic 4	Security profiles: Using FortiManager as a local FortiGuard server is discussed in this topic. Moreover, it delves into configuring web filtering, application control, and the intrusion prevention system (IPS) in an enterprise network.
Topic 5	VPN: Implementing IPsec VPN IKE version 2 is discussed in this topic. Additionally, it delves into implementing auto-discovery VPN (ADVPN) to enable on-demand VPN tunnels between sites.