The Best 156-835 Exam Study Material Premium Files and Preparation Tool (Aug-2023) [Q39-Q63]

Rate this post

The Best 156-835 Exam Study Material Premium Files and Preparation Tool (Aug-2023)

Get Instant Access to 156-835 Practice Exam Questions

NEW QUESTION 39
What is the Orchestrator?

Load balancer

Network Switch

Manager of compute and network resources, load balancer and network switch

None of above

NEW QUESTION 40
What type of cluster can a Security Group can be compared to?

VSLS

Load Sharing Active /Active

Active / Backup

Active / Standby

NEW QUESTION 41
What is the Iterator process?

Iterator is the process that simulates distribution in case of Appliance failure

Iterator is the process that follow Appliance recovery and simulates what was a distribution if recovered Appliance was alive

Iterator is the process that runs on the Orchestrator and calculates a distribution in case of Appliance failure

Iterator is the process that runs on the Orchestrator and calculates a distribution in case of Appliance recovery

NEW QUESTION 42
Which command will be used in order to restart Orchestrator service only?

orchd restart

cpstop; cpstart

reboot

service orchestrator restart

NEW QUESTION 43
When running ifconfig command on an Appliance, there are interfaces shown in the list: ethl-Sync and eth2-Sync. What is the purpose of these interfaces?

These interfaces are bond members (slaves) of Sync Bond

These interfaces can be used as backup for Sync interface

These interfaces are not in use. Security GW module use Sync interface for synchronization

These interfaces represent physical Sync interface at the front panel of appliance

NEW QUESTION 44
What is the basic installation sequence of the Orchestrator in case of single Orchestrator?
1. Create a Security Group
2. Configure Default Gateway
3. Connect with Serial Console cable to the Orchestrator
4. Configure IP for one of its Management interfaces
5. Connect an appliance to a downlink port
6. Change Orchestrator amount to 1
7. Browse to the Orchestrator’s WebUI

3-4-2-6-5-7-1

3-1-7-2-4-6-5

1-4-2-5-7-3-6

7-4-2-5-3-1-6

NEW QUESTION 45
Which file on Appliance includes information about Security Group?

/etc/chassisdb.json

/etc/sgdb.json

/etc/smodb.json

/etc/distutiljson

NEW QUESTION 46
What will happen in case of NAT of the traffic passing through Management network?

This traffic will not pass correction, since it will be dropped

This traffic will pass with no inspection

Since Management traffic is always going to SMO, it will take a care for Correction Layer and will re-distribute traffic to other Appliances

Orchestrator will disable NAT and traffic will pass with no issue

NEW QUESTION 47
In order to set Site (chassis) priority per VS, following command should be used:

From given VS context: set chassis high-availability vs chassis_priority

From given VSO context: set chassis high-availability vs chassis_priority

From any VS context: set chassis high-availability vs <vsid> chassis_priority

From VSO context: set chassis high-availability vs <vsid> chassis_priority

NEW QUESTION 48
What is the default Distribution mode?

User

Auto-topology

Manual-General

Network

NEW QUESTION 49
One single Appliance supports 1M concurrent connections. How many concurrent connections will support Security Group of 2 Appliances?

500K

NEW QUESTION 50
What cannot be learned from the output of asg perf -v -p command?

Average CPU usage on Appliances

Real-time throughput

Average CPU usage on Orchestrators

Per-path distribution

NEW QUESTION 51
There are two 10Gbps dual-port NICs and one 40Gbps NIC installed on a 23800 Appliance in slots 1, 2 and 3 accordingly. Which interfaces should be connected to Orchestrator 1 for downlinks’ intra-orchestrator redundancy when using two Orchestrators?

Any pair of available ports

Port 1 in Slot 2 and Port 2 in Slot 1

Port 1 in Slot 1 and Port 2 in Slot 1

This configuration is not supported

NEW QUESTION 52
What cannot be a reason for “Failed to get remote orchestrator interfaces” error message, when clicking on “Orchestrator” in WebUI?

Remote orchestrator has no empty interfaces

One orchestrator only, but Orchestrator amount is 2 or no Sync in between orchestrators

No Sync between orchestrators

Single orchestrator environment, but configured Orchestrator amount is 2

NEW QUESTION 53
What is the throughput penalty of Security Group?

5% per member

Depends on the type of Appliance

10% per Security Group with no relation to amount of members

1% per member

NEW QUESTION 54
What command should be used for collecting diagnostic information about the orchestrator?

cpinfo

orch_info

cpview

asg pert -v

NEW QUESTION 55
Which setting is required in order to connect an appliance with 40Gbps downlink interface and DAC to the Orchestrator MHO-140?

On Orchestrator: Change QSFP mode from 100Gbps to 40Gbps

On Orchestrator: Change port type from uplink to downlink

On Appliance: Change a port speed to 10Gbps

No change required

NEW QUESTION 56
Splitter cannot be used __________.

To connect single port on orchestrator to multiple Appliances

To connect single port on Appliance to multiple ports on the orchestrator

To connect single port on orchestrator to the same Appliance

To connect single port on orchestrator to multiple port on external switch

NEW QUESTION 57
When running asg perf -v in a Dual-Site environment, we can see only Appliances from one of the sites. That means we’re working in:

VSLS mode

Active /Active

Active / Standby HA mode

This is not Dual-Site, in Dual-Site we always see Appliances from both sites

NEW QUESTION 58
There are two appliances within the same Security Group. One of them is connected by One downlink only, another one by Two downlinks. Assuming there’s no NAT and no VPN, what would be proportion of traffic distribution done by Orchestrator?

66%/33%

100%/0%

50%/50%

33%/66%

NEW QUESTION 59
Which is a valid requirement for a supported Maestro appliance?

10GBps and 40Gbps or 100Gbps card with double-VLAN and LLDP support

At least one 10GBps line card

Nothing special as Maestro supports any Check Point appliance

Line card with double-VLAN and LLDP support

NEW QUESTION 60
On MHO-170 – In default configuration, what are GAIA names of Security Group Management ports?

eth1-Mgmt1 and eth1-Mgmt2

eth1-Mgmt1 and eth2-Mgmt1

eth1-Mgmt1 and eth1-Mgmt3

eth1-Mgmt3 and eth1-Mgmt4

NEW QUESTION 61
What command will be used for updating fwkern.conf file on all Appliances within Security Group?

g_update_conf_file

g_update_kernel

g_all update_conf_file

NEW QUESTION 62
Complete the sentence: Orchestrators works as…

Active-Active cluster

Hot-Swap RAID

Active-Standby cluster

Load Sharing cluster

NEW QUESTION 63
For a VSX configuration – Which statement is wrong?

All Virtual Systems exist on the SMO

All Virtual Systems exist on all Appliances

VSX configuration is the same on all Appliances within the same Security Group

Each Appliance owns different Virtual Systems

Validate your Skills with Updated 156-835 Exam Questions & Answers and Test Engine: https://www.dumpsreview.com/156-835-exam-dumps-review.html

Latest Exams Dumps & Reviews

The Best 156-835 Exam Study Material Premium Files and Preparation Tool (Aug-2023) [Q39-Q63]

examdumps

Leave a Reply Cancel reply

Related Posts

Leave a Reply Cancel reply